等.结构特点：1.动作机构为直动式，触头为双断点； 2.组合功能，除安装面外，其余各面均能加装附件； 3.两侧可加装辅助触头组； 4.上方可加装辅助触头组； 5.线圈接线端可加装延时或放大等各种功能模块； 6.防护式，防护等级IP10； 7.触点采用强制摩擦结构，动、静触点构成网状接触，可提高接触可靠性，并有自洁作用。 用途：JZC3-d、JZC3系列接触器式继电器适用于交流50HZ/60HZ，电压至380V及直流电压至220V的控制电路中，用于控制各种电磁线圈，放大信号或传递信号。JZC3-d系列接触器式继电器适用于交流50Hz（或60Hz），电压至380V及直流电压至220V的控制电路中，用于控制各种电磁线圈，放大信号或传递信号。断路器类二、型号及含义 TYPE AND MEANSJZC3-d系列接触器继电器JZC3-d Range Contactor Type Relay三、结构特点 STRUCTURE FEATURE△△△△△△△动作机构为直动，触头为双断点;Direction-moving, double breaking contact terminal;组合功能，除安装面外，其余各面均能加装附件；Combination function, in addition to the installation side, other surface canbe installed accessory;两侧可加装辅助触头组（F3-d1）；Both sides can be fixed auxiliary contact arrangement (F3-d1);上方可加装辅助触头组（F3-d）或空气延时头（SK4-2/3d）；Can add installation (F3-d) or air time-delay (SK4-2/3d) on above;线圈接线端可加装延时或放大等各种功能模块；Wiring terminal can be added time-delay、 expanding and other functionmodel;防护，防护等级IP10； Protect way: protect class IP10;触点采用制摩擦结构，动、静触点构成网状接触，可提高接触可靠性，并有自洁作用。Compulsory friction structure contact, dynamic-static contact constitutes netcontact; can enhance high contact reliability and have self-cleaning effect.JZC3-d系列接触器继电器适用于交流50Hz（或60Hz），电压至380V及直流电压至220V的控制电路中，用于控制各种电磁线圈，放大信号或传递信号。JZC3-d range contactor type relay is used in 50Hz (or 60Hz), in circlevoltage is up to 380V and DC voltage is up to 220V, for controlling variouselectromagnetic coil, expending information or transmission signal.型 号type电源频率powerfrequency Hz线圈电压V coil voltage24 48 110 220 380 415JZC3-d 50 / / / / Q /JZC3-d 60 / / / / / QJZC3-d 50/60 B7 E7 F7 M7 / /表(Table )1JZC3-d系列接触器继电器JZ C 3湿热带产品代号“TH”，船用产品代号“C”线圈规格代号（见表1）结构代号（d表示更新换代产品）十位数表示常触头数量 个位数表示常闭触头数量设计序号接触器继电器Humid Tropics of the product, code-named "TH",marine products, code-named "C"Specifications, code-named coil (see Table 1)Structure of the code (d that the replacement product)Ten-digit number that always contactSingle-digit number that always close contactDesign serial numberContactorRelay一、用途 APPLICATION四、工作条件和安装条件WORKING AND INSTALLATION CONDITION△△△△△△△△△△△周围空气温度-5℃～+40℃ Ambient temperature: -5℃～+40℃；安装地点海拔高度不超过2000ｍ Elevation≤2000m;最高温度为+40℃时，空气的相对湿度不超过50%，在较低的温度下可以允许有较高的相对湿度，例如20℃时达90% 。对由温度变化偶尔产生的凝露应采取特殊的措施；Not exceeding 50% at the maximum ambient temperature +40℃ . Withlower temperature, higher humidity would be permitted, such as, humidityup to 90% at the ambient temperature 20℃ . Should give consideration tothe dews on the goods surface, which would appear due to temperaturechange;污染等级为“污染等级3”； Pollution grade: Grade 3;安装类别为“安装类别Ⅲ”； Installing grade: class Ⅲ;除用螺钉安装外，还可用35ｍｍ标准卡轨安装。Mounting way: mounted on screw or with 35mm standard rail;船用接触器继电器 marine contactor way relay:周围空气温度为-25℃～+45℃； Ambient temperature: -25℃～+40℃；大气条件：可有凝露、盐雾 、油雾、霉菌、海上潮湿空气等存在；Air condition: be able to bear the influence of moisture in the air、salt fog、oil fog、 mould、humid air on the sea;各方向倾斜不超过22.5度，各方向摇摆不超过22.5度，周期10秒；The tilt and swing gradient≤22.5°, time span is 10s;振动：可安装和使用在频率2～13.2Hz，振幅为±1mm以内，或频率为13.2～2 100Hz，加速度为±7ｍ/ｓ 以内的地方；Shock: can bear frequency 2-13.2Hz and amplitude in ±1mm or frequency2 13.2～80Hz and acceleration ±7ｍ/ｓ ;电源电压和频率变化：稳态电压变化为额定值的+6%～-10%，稳态频率变化为额定值的±5%。Power voltage and frequency changes: steady-state voltage is +6%～ -10% of rated voltage, steady-state frequency change is ± 5% or ratedfrequency.■JZC3-d系列接触器继电器五.规格 CHARACTERJZC3-40d 4 0JZC3-31d 3 1JZC3-22d 2 2JZC3-13d 1 3表(Table )2继电器规格 触头数量 contact volumetype常JZC3-d系列接触器继电器六.主要技术参数MAIN TECHNICAL PARAMETERS常常闭换接时间NO,NC access time1.5ms动作时间Time movesNO 通 15-22ms NO 断 5-15msNC 通 9-22ms NC 断 7-20ms瞬时过电流允许值1s 100A500ms 120A100ms 180A2 接线能力mmwire capacity1或2根1 or 21或2根1 or 22.54JZC3dIIC60947-5 GB14048.5690AC：380 DC：220约定自由空气发热电流（l ）A th 10额定工作电（le）A（电感负载）Rated current (le)A (inductive load)AC-15（380V）DC-13（220V）0.950.15可接通最小负载（可靠工作）Can be connected to the minimum load (and reliable work) 24V 10mA额定操作频率(次/小时)Rated operating frequency (times / h)2400寿命 life6 10×10 次6 1.2×10 次额定控制电压（Us）VRated voltage control24、48、110、220、3800.85～1.1Us0.2～0.75Us70VA8VA/1.8-2.7W102500V:1分钟七、外型与安装尺寸 OUTLINE AND MOUNTING SIZE表(Table )3注(remark) :a1:JZC3-d+2(F3-d1)C1:JZC3-d+(F3-d)C2:JZC3-d+(SK4-2/3d)Cmax:JZC3-d型 号 type符合标准standard额定绝缘电压（Uｉ）V Rated insulation voltage额定工作电压（Uｅ）V Rated work voltage机械machine电 electric吸合电压 pull voltage释放电压 release voltage吸合功率 pull保持功率/功耗 contain power绝缘电阻MΩ is olated resistant耐压（AC）containing voltage参数 parameters线圈参数Coilpara-metersTransient over-currentvalue of the allowed软线Soft Line硬线Hard Line八、接线图 WIRING PICTURE九、订货须知 ORDER NOTICE■■在订货时指明下列事项 ：In order need attention following:继电器的全型号和名称； Entitle type of contactor;控制线圈的频率及额定电压；Frequency and voltage of control coil;订货数量；Order volume例如：JZC3-22d接触器继电器AC 50Hz 220V 10台Example: JZC3-22d contactor way relay AC 50Hz 220V 10sets额定控制电压未列入表1的规格，如用户需要可特殊订货。Special rated control voltage character product, can special customize ifneed△△△JZC3-d系列接触器继电器型号type amax Cmax C1 C2 a1JZC3-d 47 82 115 134 75表(Table )4JZC3-40d JZC3-31d JZC3-22d JZC3-13d